Research on Maintenance and Replacement technology of Space Mechanical Arm

Yuhang Xing

doi:10.54097/kmc0mr60

Authors

Yuhang Xing

DOI:

https://doi.org/10.54097/kmc0mr60

Keywords:

Maintenance; Fault diagnosis; Parts replacement; System test; Space Mechanical Arm.

Abstract

This paper presents the station arm structural components and discusses the importance and challenge of station arm maintenance. The article provides the main process of the maintenance of the space station robotic arm, including the troubleshooting, the replacement and maintenance of parts, and the calibration and testing of the system. At the same time, the article also points out that the mechanical arm failure may be caused by a variety of factors, including electrical failure, mechanical failure and environmental failure, and shows some classic cases and summarizes the experience. This paper shows the development process of maintenance technology and the current research status quo. Finally, it is pointed out that the maintenance of the space station robotic arm still faces many difficulties and risks, which need further research and improvement.

Downloads

Download data is not yet available.

References

Wen, Z., Wang, Y., Di, N., etc. (2015) Rapid identification of cooperative targets in space station robotic arm pose measurements. Journal of Aeronautical, 36(04):1330-1338.

Jiao, J., Ying, J., Shi, S. (2018) Preliminary design and development of an active suspension gravity compensation system for ground verification. Mechanism and Machine Theory, 128.

Jiang, B., Wang, J., Soh, Y.C. (2002) An adaptive technique for robust diagnosis of faults with independent effects on system outputs. International Journal of Control, 75(11): 792-802

Jia, Q., Fu, Y., Chen, G., etc. (2021) Space robotic arm joint fault diagnosis based on a state observer. Journal of Aeronautical, 42(01):165-175.

Gao, X. , Wang, Y. , Sun, H. , Jia, Q. , Yang, X. , & Du, M. , et al. (2015). Research on construction method of operational reliability control model for space manipulator based on particle filter. Mathematical Problems in Engineering, Pt.23: 1-11.

Zheng, P., Bao, S., Zong, W., et al. (2023) Kinematic Calibration of a Space Manipulator Based on Visual Measurement System with Extended Kalman Filter. Machines, 11(3).

Mohammadhosein, B., Meysam, Y., Nader, M. (2022) Data-driven fault detection and isolation of nonlinear systems using deep learning for Koopman operator. ISA transactions, 134.

Meslem, N., Loukkas, N., Martinez, J. (2018) Using set invariance to design robust interval observers for discrete‐time linear systems. International Journal of Robust and Nonlinear Control, 28(11).

Zhang, J., Lin, F. (2012) Robust detection method of aviation engine sensor fault. Computer Simulation, 29(02):32-35.

Hu, C., Gao, S., Xiong, M., etc. (2022) Key technology of the space station core module manipulator. Chinese science: Technical science, 52(09):1299-1331.

Meng, G., Liu, C., Yang, D., etc. (2013) Analysis of the first flight of the ship and enlightenment and suggestions for the development of China's space industry. Acta Aeronautica ET Astronautica Sinica, 15.

Late confusion. (2022) World Aerospace: A ray of sunshine under the haze of the epidemic. Space Exploration, 01:20-33.

Liu, Y. (2022) On-orbit maintenance dynamics and control of space robotic arms facing a maintainable spacecraft. Thesis of Harbin Institute of Technology.

Feng, B. (2022) Research on quick replacement end actor tors for light robotic arm. Thesis of Harbin Institute of Technology.

He, Y. (2016) Design and study of quick change interface of robotic arm in laboratory chamber. Thesis of Harbin Institute of Technology.

Xu, J., Mei, T., Luo, M. (2006) Development of an automatic hand claw replacement device for a space robot. Industrial instruments and automation devices, 04:13-16.

Liu, Q. (2012) Research on the end-tool replacement device in the space robot. Thesis of Harbin Institute of Technology.

Li, D., Zhu, C., Zhang, Y., et al. (2022) Design and test verification of space station robotic arm. Manned Space Flight, 28(5):666-674.

Li, J. (2012) Design and control of space mechanical arm. Thesis of Shanghai Jiao Tong University.

Zhu, C., Zhang, W., Hu, C., et al. (2023) Design and verification of space station mechanical arm end actuator maintenance system. National space science and technology, 43(5):79-86.