Overview of Inductive Wireless Charging
DOI:
https://doi.org/10.54097/p1hgeq35Keywords:
Wireless Charging; Electrical Vehicles; Compensation Typology; Inductive Power Transfer; Magnetic Coupler.Abstract
Electric transportation is gaining popularity due to its cost-effectiveness and convenience compared to traditional fuel cars. Electric vehicles (EVs) offer the advantage of reducing greenhouse gas emissions, making them more environmentally friendly. To promote widespread adoption of EVs, it is essential to establish a large number of charging stations in an EV-friendly environment. However, the current challenge lies in the daily battery charging difficulty for EV owners. Wireless charging technology provides a promising solution as it is both eco-friendly and convenient without the need for plug-ins. This alternative technology can replace traditional plug-in charging stations with wireless charging systems using wire power transfer (WPT). Although WPT may result in some power wastage compared to wired methods, it presents new opportunities for more convenient EV charging.
Downloads
References
[1] Mak, H. Y., Rong, Y., & Shen, Z. J. M. (2013). Infrastructure planning for electric vehicles with battery swapping. Management science, 59(7), 1557-1575.
[2] Alkawsi, G., Baashar, Y., Abbas U, D., Alkahtani, A. A., & Tiong, S. K. (2021). Review of renewable energy-based charging infrastructure for electric vehicles. Applied Sciences, 11 (9), 3847.
[3] Mohamed, A. A., Shaier, A. A., Metwally, H., & Selem, S. I. (2023). Wireless charging technologies for electric vehicles: Inductive, capacitive, and magnetic gear. IET Power Electronics.
[4] Shevchenko, V., Husev, O., Strzelecki, R., Pakhaliuk, B., Poliakov, N., & Strzelecka, N. (2019). Compensation topologies in IPT systems: Standards, requirements, classification, analysis, comparison and application. IEEE Access, 7, 120559-120580.
[5] Aditya, K. (2016). Design and implementation of an inductive power transfer system for wireless charging of future electric transportation (Doctoral dissertation).
[6] Kan, T., Nguyen, T. D., White, J. C., Malhan, R. K., & Mi, C. C. (2016). A new integration method for an electric vehicle wireless charging system using LCC compensation topology: Analysis and design. IEEE Transactions on power electronics, 32 (2), 1638-1650.
[7] Budhia, M., Covic, G. A., Boys, J. T., & Huang, C. Y. (2011, September). Development and evaluation of single sided flux couplers for contactless electric vehicle charging. In 2011 IEEE Energy Conversion Congress and Exposition (pp. 614-621). IEEE.
[8] Zaheer, A., Kacprzak, D., & Covic, G. A. (2012, September). A bipolar receiver pad in a lumped IPT system for electric vehicle charging applications. In 2012 IEEE Energy Conversion Congress and Exposition (ECCE) (pp. 283-290). IEEE.
[9] Lu, F., Hofmann, H., Deng, J., & Mi, C. (2015, March). Output power and efficiency sensitivity to circuit parameter variations in double-sided LCC-compensated wireless power transfer system. In 2015 IEEE applied power electronics conference and exposition (APEC) (pp. 597-601). IEEE.
Downloads
Published
Issue
Section
License
Copyright (c) 2024 Academic Journal of Science and Technology
This work is licensed under a Creative Commons Attribution 4.0 International License.
How to Cite
