Abrasive Slurry Jet Characteristics Study
DOI:
https://doi.org/10.54097/8n20yx13Keywords:
VES surfactant; Abrasive jet; Numerical simulation; Particle acceleration.Abstract
In this paper, a coupled computational fluid dynamics-discrete element (CFD-DEM) approach is used to investigate the performance of abrasive slurry jets. Firstly, the CFD method was used to simulate the VES slurry jet flow characteristics. Secondly, an orthogonal design method was used to analyse the sensitivity of the parameters of zero shear viscosity , relaxation time and flow index of the Cross fluid, in which zero shear viscosity had the most significant effect on the flow field. As the zero-shear viscosity increases, the velocity of the flow field gradually increases, but the core section of the jet becomes less concentrated and the core section of the jet decreases. Based on the VES fluid formulation used in this project, the optimum zero-shear viscosity, relaxation time and flow index were optimised to 2.5 Pa-s, -0.1s and 0.2 respectively. The results showed that the addition of VES surfactant enhanced the erosion rate of the specimens and that the erosion rate increased with increasing OTAC concentration.
Downloads
References
Jiao L F, Li F C. A review of research on additive turbulent drag reduction flow and heat transfer[J]. Advances in Mechanics,2008(03):339-357.
Minghui W, Chenghuai W, Yanxi Z. Numerical Simulation and Experimental Study on Flow of Polymer Aqueous Solution in Porous Jet Nozzle[J]. Advances in Polymer Technology, 2020,2020.
Wang F, Zhou D, Xu Q, et al. Mathematical model of rock stress under abrasive slurry jet impact based on contact mechanics[J]. International Journal of Rock Mechanics and Mining Sciences, 2018,107:1-8.
Li G, Deng S, Guan J, et al. Numerical analysis on cavitation effects in submerged water jet added with turbulent drag-reducing additives [J]. Chemical Engineering Science, 2018, 196.
YANG Shengfa,HUANG Dai,ZENG Shiyu. Effect of ambient flow velocity on the flow field characteristics of abrasive water jets under submerged conditions[J]. Vibration and Shock, 2019, 38(8):7.
Kang Can. Fundamentals and applications of high-pressure water jet technology [M]. Mechanical Industry Press,2016.
Wang Changbin,Shen Yanxia,Liu Zhaodong,et al. Numerical simulation of the submerged abrasive jet field with a tapered straight nozzle[J]. Journal of Daqing Petroleum Institute, 2022(1).
Zhu G, Li H, Wang Z, et al. Semi-resolved CFD-DEM modeling of gas-particle two-phase flow in the micro-abrasive air jet machining [J]. Powder technology, 2021,381:585-600.
Zhang Xueqiang. Design and research of pneumatic conveying device based on EDEM-FLUENT coupling[D]. Xihua University, 2015.
WANG Zhiguo,LIN Jingjie,GUO Jiangru,et al. Numerical simulation of clean fracture fluid proppant placement behavior in fractures based on Cross instantonal equation[J]. Journal of Xi'an University of Petroleum (Natural Science Edition), 2021, 36(03):42-49.
WANG Zhiguo, WANG Shuzhong, SUN Xiao, et al. Microstructure and linear viscoelasticity of OTAC/nasal worm-like micellar fluid[J]. Journal of Mechanics, 2013, 45(6): 7.
Downloads
Published
Issue
Section
License
Copyright (c) 2024 Academic Journal of Science and Technology

This work is licensed under a Creative Commons Attribution 4.0 International License.








