Analysis of Electromagnetic Interference Reduction from Printed Circuit Boards
DOI:
https://doi.org/10.54097/hset.v27i.3718Keywords:
electromagnetic interference (EMI), printed circuit boards (PCB).Abstract
Nowadays, electricity is the most important and necessary energy in human society and daily life, because electricity is convenient and safe to transfer between different locations. However, electromagnetic interference (EMI) always accompanies electricity and has brought a lot of problems. Especially in printed circuit boards (PCB), the EMI can break the circuit or cause a short circuit, which is dangerous in creating a PCB. To effectively reduce EMI from PCB, three different methods of reducing EMI from PCB were chosen to compare with each other. By comparing their price, practicability, effectiveness, data, and technology for reducing EMI from PCB, PCB designers can choose the methods that are suitable for their situation.
Downloads
References
Paul C and Nasar S 1987 Introduction to electromagnetic fields, 2nd ed. McGraw-Hill, New York.
Montrose M 1996 Printed circuit board design techniques for EMC compliance
Brist G, Krieger J and Willis D 2012 Pcb trace impedance: impact of localized pcb copper density 1–9, Intel Corp.
Senthinatan R and Price J 1994 Simultaneous switching noise of cmos devices and systems Norwell, MA: Kluwer.
Radu S and Hockanson D 1999 An investigation of pcb radiated emissions from simultaneous switching noise in Proc. IEEE Int. Symp. Electromagnetic Compatibility, vol. 2, Seattle, WA, pp. 893–8.
Shantala and Sudheer 2018 Analysis of electromagnetic interference radiations from the pcb traces International Conference on Recent Trends in Electrical, Control and Communication (RTECC), pp. 74-8.
Ye X, Hockanson D, Li M, Ren Y, Cui W, Drewniak J and DuBroff R 2001 Emi mitigation with multilayer power bus stacks and via stitching of reference planes IEEE Trans. Electromagn. Compat., vol. 43, pp. 538–48.
Shahparnia S and Ramahi O 2004 Electromagnetic interference (emi) reduction from printed circuit boards (pcb) using electromagnetic bandgap structure in ieee transactions on electromagnetic compatibility, vol. 46, no. 4, pp. 580-587, Nov. 2004.
Montrose M 2000 Printed circuit board design techniques for emc compliance, IEEE press series.
Virdi A, Salunkhe P, Choudhary D and Mahadik T 2018 Enhancement of pcb design for radiated immunity compliance in analog signal measurement international conference on electromagnetic interference & compatibility (inceimc) pp.1-4.
Downloads
Published
Issue
Section
License
This work is licensed under a Creative Commons Attribution-NonCommercial 4.0 International License.
