A Balanced OTA ECG Amplifier and Its Development Directions
DOI:
https://doi.org/10.54097/hset.v32i.4985Keywords:
Ecg, Ota, Denosing, DevelopmentAbstract
Electrocardiograph (ECG) is a technology that uses an electrocardiograph to record the electrical activity change pattern generated by each cardiac cycle of the heart from the body surface. It is a simple test that can be used to check heart's rhythm and electrical activity of human. The amplifying and filtering of the ECG signal is the most important part of ECG signal procedures and this paper shows a balanced OTA that can fully remove the 50hz noise from the power line. Due to cost performance for the real situation in the hospital and industrial cost, the balanced OTA filter in this paper is simple and cannot guarantee a long stable use when it is implemented on an ECG machine with other models. This paper will show two different ways to increase gain and power efficiency which are using fully differential OTA and using higher bandwidth.
Downloads
References
Das, M., and Ari, S. Analysis of ECG signal denoising method based on S-transform. IRBM, 2013. 34(6):362-370.
Pasolli, E., and Melgani, F. Genetic algorithm-based method for mitigating label noise issue in ECG signal classification. Biomedical Signal Processing and Control, 2015. 19:130-136.
Alvarado-Serrano, C., Luna-Lozano, P. S., and Pallàs-Areny, R. An algorithm for beat-to-beat heart rate detection from the BCG based on the continuous spline wavelet transform. Biomedical Signal Processing and Control, 2016. 27:96-102.
Xiao, Q. An Adaptive Filter Denoising Based on Wavelet Transform Applied in ECG Signal. Advanced Materials Research, 2012. 610-613:2521-2524.
Stracina, T., Ronzhina, M., Redina, R., and Novakova, M. 2022. Golden Standard or Obsolete Method? Review of ECG Applications in Clinical and Experimental Context. Frontiers in Physiology, pp 13.
Cho, T., & Gray, P. 1995. A 10 b, 20 Msample/s, 35 mW pipeline A/D converter. IEEE Journal of Solid-State Circuits, vol 30(3), pp 166–172.
Dassi, M., & Sharma, R. 2014. Design of RF Low Noise Amplifier at 2GHz in 0.18µm Technology. Journal on Today’s Ideas - Tomorrow’s Technologies, vol 2(2), pp 107–115.
Ahmadi, M. 2006. A new modeling and optimization of gain-boosted cascode amplifier for high-speed and low-voltage applications. IEEE Transactions on Circuits and Systems II: Express Briefs, vol 53(3), pp 169–173.
Shao Zijian, and Bai Chunfeng. 2021. A fully differential operational transconductance amplifier with high gain and high power consumption efficiency. Microelectronics, vol 51(06), pp 818-821.Zheng Kailun, and Guo Guiliang. 2020. An operational transconductance amplifier with high gain and high current efficiency. Microelectronics and computer, vol 37(06), pp 51-56.
Downloads
Published
Issue
Section
License
This work is licensed under a Creative Commons Attribution-NonCommercial 4.0 International License.
