A Review of Innovative Comparator Designs
DOI:
https://doi.org/10.54097/hset.v27i.3726Keywords:
Comparator, Floating Inverter Amplifier, Local Clock Generator, Dynamic bias.Abstract
Three papers on the optimal design of comparator circuits are further analyzed in this work. Each paper presents a method to improve the performance of comparators. Floating inverter amplifier applied an independent capacitor as the source of the preamplifier, which improves the overall performance of the circuit. In another design, a special local clock generator is proposed to control the input of both of the latch stage and the preamplifier, which makes it possible to adjust the speed and improve the energy efficiency. In dynamic bias circuit design, stabilized common-mode voltage is realized by adding a capacitor to the tail of the pre-amplifier of a latch-type comparator, optimizing the power and noise performance successfully.
Downloads
References
Tang X, et al. An Energy-Efficient Comparator With Dynamic Floating Inverter Amplifier [J]. IEEE Journal of Solid-State Circuits, 2020, 55(4): 1011-1022.
Khorami A and Sharifkhani M. A Low-Power High-Speed Comparator for Precise Applications [J]. IEEE Transactions on Very Large Scale Integration (VLSI) Systems, 2018, 26(10): 2038-2049.
Bindra H S, Lokin C E, Schinkel D, Annema A and Nauta B. A 1.2-V Dynamic Bias Latch-Type Comparator in 65-nm CMOS With 0.4-mV Input Noise [J]. IEEE Journal of Solid-State Circuits, 2018, 53(7): 1902-1912.
Akter M S, Makinwa K A A, and Bult K. A capacitively degenerated 100-dB linear 20–150 MS/s dynamic amplifier [J]. IEEE J. Solid-State Circuits, 2018, 53(4): 1115–1126.
Shen L, et al. A 0.01 mm2 25 µW 2MS/s 74 dB-SNDR continuous-time pipelined-SAR ADC with 120fF input capacitor [C]. IEEE Int. Solid-State Circuits Conf. (ISSCC), 2019, pp: 64–66.
Cho T B and Gray P R. A 10 b, 20 Msample/s, 35 mW pipeline A/D converter [J]. IEEE J. Solid-State Circuits, 1995, 30(3): 166–172.
Miyahara M, Asada Y, Paik D, and Matsuzawa A. A low- noise self-calibrating dynamic comparator for high-speed ADCs [C]. Proc. IEEE Asian Solid-State Circuits Conf. (A-SSCC), 2008, pp: 269–272.
Nikoozadeh A and Murmann B. An analysis of latch comparator offset due to load capacitor mismatch [J]. IEEE Trans. Circuits Syst. II, 2006, 53(12): 1398–1402.
Schinkel D, Mensink E, Klumperink E, van Tuijl E, and Nauta B. A double-tail latch-type voltage sense amplifier with 18ps setup+hold time [C]. IEEE Int. Solid-State Circuits Conf. (ISSCC), 2007, pp: 314–605.
van Elzakker M, van Tuijl E, Geraedts P, Schinkel D, Klumperink E A M, and Nauta B. A 10-bit charge-redistribution ADC consuming 1.9 μW at 1 MS/s [J]. IEEE J. Solid-State Circuits, 2010, 45(5): 1007–1015.
Nuzzo P, De Bernardinis F, Terreni P, and van der Plas G. Noise analysis of regenerative comparators for reconfigurable ADC archi- tectures [J]. IEEE Trans. Circuits Syst. I, 2008, 55(6): 1441–1454.
Sepke T, Holloway P, Sodini C G, and Lee H S. Noise analysis for comparator-based circuits [J]. IEEE Trans. Circuits Syst. I, 2009, 56(3): 541–553.
Downloads
Published
Issue
Section
License

This work is licensed under a Creative Commons Attribution-NonCommercial 4.0 International License.







