Investigating Corrosion of Low Alloy Steel Detection Method based on Wire Beam Electrode
DOI:
https://doi.org/10.54097/hset.v56i.10584Keywords:
corrosion, WBE, low alloy steel, detection method.Abstract
A wire beam electrode (WBE) method for investigating the local corrosion has been demonstrated by mapping non-unifore corrosion processes occurring on low alloy steel in solution of H3BO3 concentrations. It was found that low alloy steel from the sporadic points at the beginning of the test, the local corrosion range is the largest when it develops for 24 h and obvious local corrosion appeared, then it decreases when it reaches 48 h. To sum up, it is feasible to study the behaviors of low alloy steel localized corrosion with WBE.
Downloads
References
V. Kain, S. Roychowdhury, and T. Mathew. “Flow accelerated corrosion and its control measures for the secondary circuit pipelines in Indian nuclear power plants,” Journal of Nuclear Materials, vol. 383(1-2), pp. 86-91, 2006.
F Li, J congleton. “Stress corrosion cracking of a low alloy steel to stainless steel transition weld in PWR primary waters at 292°C,” Corrosion Science, vol. 42, pp. 1005-1021, 2000.
K. Ting, P. Ma. “The evaluation of erosion/corrosion problems of carbon steel piping in Taiwan PWR nuclear power plant,” Nuclear Engineering & Design, vol. 191(2), pp. 231-243, 1996.
T. Yongjun, S. Bailey, B. Kinsella. “Mapping non-uniform corrosion using the wire beam electrode method. II. Crevice corrosion and crevice corrosion exemption,” Corrosion Science, vol.43(10), pp. 0-1929, 2010.
Y Xu, T. Yongjun. “Probing the initiation and propagation processes of flow accelerated corrosion and erosion corrosion under simulated turbulent flow conditions,” Corrosion Science, vol.151, pp. 163-174, 2019.
A. Campbell, S. Fyfitch, T. Martin. "Boric acid corrosion of carbon and low alloy steels," 1994.
Downloads
Published
Issue
Section
License
This work is licensed under a Creative Commons Attribution-NonCommercial 4.0 International License.
